Lancer Tactical LT-34 Gen-2 Proline Battle Hawk AEG
  • -£10.00
  • New product
  • Lancer Tactical LT-34 Gen-2 Proline Battle Hawk AEG

Lancer Tactical LT-34 Gen-2 Proline Battle Hawk AEG

£289.99 Save £10.00
Click and Collect from our store Today

Lancer Tactical LT-34 Gen-2 Proline Battle Hawk AEG

VCRA Applicable Item:

You must be over 18 and have a valid defence under the Violent Crime Reduction Act 2006 to purchase this item. Please enter your defence details (eg. UKARA, Site Membership, Re-Enactment Society Membership etc...)in the comments box during checkout.

If you don't have a valid defence, please add our Two Tone Service before checking out.

Avavilable In-Store and Online

Lancer Tactical LT-34 Gen-2 Proline Battle Hawk AEG

Full metal, aluminum body and handguard, mosfet, ETU.

The most important evolution of the new generation 2 Proline is undoubtedly the original addition of an ETU electronic trigger and a protection mosfet. This trigger allows increased responsiveness, finer trigger travel sensitivity, battery voltage protection, count gearbox cycles, spring pre-compression for a much faster start of fire, etc... small revolution, always at an affordable price.


  • Lancer Tactcial Engraved Metal Gearbox Shells
  • 18:1 ratio steel gears
  • Sector Gear Delay
  • 8mm bearings
  • 14 tooth steel piston
  • Red anodized cylinder for improved surface finish
  • Hi-speed motor with Neodyn magnets 25000rpm
  • QD steel spring guide on bearings
  • Spring M90
  • Quick spring change (QD)
  • Shielded low resistance wiring
  • Hi-speed type metal trigger
  • "Fast trigger" electronic trigger block with increased responsiveness and higher rate of fire
  • 16AWG shielded wiring (rear)
  • Protective Mosfet in the stock tube (battery protection)

Internal parts:

  • 6.03mm precision polished brass barrel
  • Center wheel hop-up block (Gen 2)
  • 50° hop-up rubber

External parts:

  • Aluminum body
  • Metal outer barrel
  • Folding Nylon fiber sight
  • Ergonomic metal saddle
  • Aluminum M-LOK handguard
  • Single point steel sling attachment
  • Polymer crane stock (allows to insert double and triple stick batteries)
  • CNC aluminum stock tube
  • Steel dummy cylinder head
  • Steel cocking lever with hi-speed handle
  • Steel magazine catch
  • Bolt catch (non functional) in metal
  • 120-round metal mid-cap magazine
  • Semi and full auto
  • Flash hider with 14mm CCW screw pitch (anti-hotary)

Battery and battery charger not included